|
|
|||||||
| Notices | |
| Pnumatic Spearguns Discuss Pnumatic Speaguns in here |
|
|
LinkBack (2) | Thread Tools |
|
#1
|
|||
|
|||
I have several Nimrod guns that I love and have been using for over forty years. I have finally run out of spare seals. Does anyone know where thay can be obtained? I contactes a rubber mfg, and they said a mold would cost three grand. To much for my blood. Can anyone help?
Last edited by mstromberg; May 19th, 2007 at 15:31. Reason: spelling |
|
#3
|
||||
|
||||
I found the o-rings for my nemrod were pretty generic. The seal at the back of the piston was one-off though. I don't recall the diameter of the barrel - if the piston is 13mm like many guns on the market you might be able to use some parts from them.
|
| Bookmarks |
| Thread Tools | |
|
|
|
LinkBack to this Thread: http://forums.deeperblue.com/pnumatic-spearguns/71565-nimrod-pnumatic-parts.html
|
||||
| Posted By | For | Type | Date | |
| Cash Loan - loan interim cash, cash easy | This thread | Refback | June 2nd, 2007 06:15 | |
| Debt Consolidating Loan - loan consolidating bad, debt loan acs | This thread | Refback | June 1st, 2007 01:59 | |